RENTHAL grip glue
A highly developed grip glue for securing RENTHAL handlebar grips
Fitting instructions:
- Make sure all surfaces are clean and dry.
- Apply glue generously to handlebar, barrel of twist grip and inside flange ends of grips. (With open-ended twist grips, avoid getting glue into open end.)
- Install grips IMMEDIATELY, rotating approximately half a turn to ensure that glue is evenly spead.
- Wipe off surplus glue at flange end.
- ALLOW 8 HOURS TO DRY. IMPORTANT: DO NOT MOVE WITHIN DRYING PERIOD.
- After drying period, make sure that twist grip turns freely. If any friction is felt because of solidified excess glue, remove with a sharp knife.
Weight: 40g
